Saitek Rudder Pedals issue

[BH_Fw_Wingover]

I opened up the saitek pro flight quadrant smart technology software.
The Deadzone tab shows the travel amount of the 3 levers with controls to set the dead zone.

My X axis (throttle lever, left lever, black knob) maxes out at 1/2 tick mark below max. (instead of going full right)

My Y axis (middle handle, Prop control blue knob) works full travel but when I pull the Z axis to zero (full aft on the red knob right lever), the Y axis follows it down.
No idea why. Has any one experienced the same thing?

[BH_Vfw_ Klaue]

S! Wingover I have never used the software to keep from having issues.You can try to delete the software unplug your controller and start your pc and then plug the controller back in.It should reset it and just assign the levers in ROF.That is the way that i have it set it could help.Good luck.

[BH_loopy]

wingover if you have reinstalled windows, check for windows update for saitek [HID] under optional

[BH_Fw_Wingover]

Thanks guys. I 'm going to incorporate all the suggestions. delete and reinstall, update if one exists, and Hawkeye's 2% dead zone. Maybe that's why I'm always the tail-end Charlie...
Thanks again.